PH-Neutralisation with CO2

PH-Neutralisation with CO2
Typically, the ASCO CO2 Gas Dosing System is used together with water desalination plants. The system is equipped with a CO2 pressure reducing valve, filtration unit, CO2 gas flowmeter, CO2 regulating valve, pressure gauges, safety valves and a completely pre-wired control cabinet. In case of maintenance the system provides a manual by-pass line, which also can be monitored by the flowmeter. Herefore, changing a filter cartridge or doing any other service work on the system is quick and easy!
As raw and fitting material ASCO uses mainly stainless steel. This makes the system very resistant and extends the products life cycle.
Advantages
• easy to install | |
• very accurate | |
• 4 - 20 mA output signal | |
• robust stainless steel construction | |
• no auxiliary equipment like air compressor needed, only power supply is required |
We are happy to advise you by telephone if you have any questions about our product. Or simply write to us via our contact form
+1 (877) 633-0996 (Toll free)
Site conditions
Min. ambient air temperature | 10 °C, optional with heater for vaporiser down to 4 °C |
Max. ambient air temperature | 38 °C, optional with air conditioned cabinet up to 50 °C |
Humidity | 34 % to 99 % |
Wind speed max | 19.03 m/s (62 ft/s), tank foundation must be recalculated by local civil engineer |
Uniform building code | seismic zone 2A |
Temperature treated water | 15 to 35 °C |
Side stream water pressure | 4 bar (58 psi) max. |
Ask for more information:
Ancillary CO2 Equipment
- ASCO Atmospheric CO2 Vaporiser
- ASCO CO2 Vaporiser - Individual Solutions
- ASCO CO2 Cylinder Filling System LH900
- ASCO CO2 Transfer Pump
- ASCO CO2 Gas Purity Tester
- ASCO CO2 Carbonation Tester
- ASCO CO2 Dew Point Tester
- ASCO CO2 Flowmeter
- ASCO CO2 Pressure Reducing Valve
- ASCO CO2 Gas Detector
- PH-Neutralisation with CO2